Tough Water Based Red Oxide
Specifications
Red Oxide is a metal primer designed to combat rust and corrosion. Our water-based red oxide can be used as base layer for ToughRoof or ToughSealer or as a paint on its own.
Its uses can vary widely from implements to roofs to any other metal surfaces. Its water and weather resistant qualities make it ideal for farms and factories and even household application
The Terracotta colour is unique to our ToughPrimer and is designed to look more stylish and decreased fading
It is important to get the surface clean and dry
Remove dirt, leaves and other debris
Loose, flaking paint must be removed
Ferrous surfaces: Remove rust on the surface
Previously painted surfaces to be prepared in line with the NHBRC and SABS standards
Before paint is applied it must be mixed/stirred properly
Ready for use with brush, roller or airless sprayer
The ideal application conditions are a surface ambient temperature of 10°C and a maximum of 35°C with a relative humidity of 80% maximum
If used as paint on its own, preferably 2 coats are required
Allow the first coat to dry for at least 4 Hours
Ensure your paint is applied smoothly if used as a primer
For optimal results use with ToughRoof and ToughSealer
Areas of algae, mildew or fungus should be treated first before painting
Application tools and equipment can be cleaned with water
Roofs become slippery when wet. Use extreme caution!
Store away from direct sunlight, heat and severe cold
Use containers with the same batch numbers for large areas
Ensure the surface is well prepared and dry before applying
Type: Pure Acrylic Emulsion
Drying time (Depending on temperature):
Surface Dry: 30 Min - 1 hour
Totally Cured: 3-4 hours
Recoating time: 4 Hours
Application Temperature: 10-35°C
Viscosity: 100 – 110 Krebs Unit
Relative density: 1.24 – 1.40 SG
Solids by Volume: 28-33%
Spread rate: 5 – 8 m2/litre (Depending on surface)
Gloss Level: Low Sheen Finish